65 Vs 66 Mustang

65 Vs 66 Mustang. Although 1965 and 1966 Mustangs are very similar in design there are easy ways to tell the difference between the two The first place to look is.

May 14 2019 #1 The factory 64/65 V8 trans cooler lines consist of the following * two fittings at radiator * two short pieces of rubber hose * two preformed lines going to trans * one 90 degree adapter fitting that screws into the rear return line port in the trans In 66 the 7 components above appear to be combined into just two lines hot and return.

'65 VS '66 Motor Mounts Vintage Mustang Forums

The ’65 Mustang body is thinner and a bit lighter (unless it’s a rare mohogany body) I appreciate the aesthetics of a contoured body but in this case my vote goes to the first generation vintage slab Because it’s such a light petite body the contour doesn’t have as much functional value as on a heavier or bigger body.

1966 vs 1967 Mustang Similarities And Differences CJ

The difference between a ’65 and a ’66 is a little easier to distinguish The grille on a ’65 will have vertical bars and the ’66 grille will not have them (except GTs) The side scoops on the ’65 have have a single scoop while the ’66 has 3 horizontal trim pieces along the scoop Stock hubcaps were also different for both years.

64½ Mustang FAQ & 64½ vs. 65 Mustang Differences

The 1965 Mustang had a threenotched gas cap design and the 1966 had small ridges around the exterior The 1967 gas cap combines these creating three blades almost surrounded by a ring of ridging 1967 Mustang Gas Cap and Taillights Options In 1967 for the first time an “Exterior Decor Group” was made available.